Table of Contents
Advertisement
Installing a Passive CPU Heatsink
1. Do not apply any thermal grease to the heatsink or the CPU die -- the
required amount has already been applied.
2. Place the heatsink on top of the CPU so that the four mounting holes are
aligned with those on the serverboard and the heatsink bracket underneath.
3. Screw in two diagonal screws (i.e., the #1 and the #2 screws) until just snug
(to avoid possible damage to the CPU do not over-tighten the screws.)
4. Finish the installation by fully tightening all four screws.
Screw#4
SNK-P0057PS
Chapter 5: Advanced Serverboard Setup
Screw#1
5-7
Screw#3
SNK-P0047PSM
Screw#2
Advertisement
Table of Contents
