P/O Adjust Switches #1 - #4; Power On/Off Switch And 5-Pin Primary Plug For Diamond Dc Board; Battery Replacement When Necessary - Eagle 100 Series Installation & Owner's Manual

Diamond DC Board ONLY

P/O Adjust Switches #1 - #4

Not used, leave in OFF position.
Power Indicator LEDs
When ON, Indicates AC input power is connected to
operator and functioning normally.
When ON, Indicates low battery power. Charging will
automatically start when operator is able.

Power ON/OFF Switch and 5-Pin Primary Plug for Diamond DC Board

5-Pin Primary Plug:
Connects and disconnects
ALL power to the operator
(AC AND Battery Power).
IMPORTANT: Batteries will
NOT charge unless plug is
connected into Diamond
DC board.

Battery Replacement When Necessary

Normal battery deterioration will take place over time and batteries will need to be replaced eventually. Remove the 5-Pin Primary Connector
(White Plug) from Diamond DC Board BEFORE replacing the Eagle Battery Pack.
IMPORTANT: Use only Eagle Battery Pack in your Eagle gate operator.
+ –
OFF 1
OFF 2
OFF 3
P/O ADJUST
AC POWER SOLAR
24VAC POWER
LOW CHARGER
BATTERY ON
Power Switch
OFF
SELECT
LIGHT HEAVY
ACTIVE
SLAVE MASTER
OPEN LEFT OPEN RIGHT
BRAKE OFF BRAKE ON
MH1 REVERSE LOOP NO REVERSE LOOP NC
OVERLOAD
ONE PASS OFF ONE PASS ON OPENING CLOSING
STOP-REVERSE OFF STOP-REVERSE ON
ALARM-RESET OFF ALARM-RESET ON
CLOSE TIMER OFF CLOSE TIMER ON TIMER ERD STATUS
MH2
OFF—ON
PWR FAIL OPERATION
0 1
AUTO OPEN OFF AUTO OPEN ON + –
POWER FAIL OPEN POWER FAIL CLOSE OFF 1
OPEN DELAY MASTER OFF OPEN DELAY MASTER ON OFF 2
OPEN DELAY SLAVE OFF OPEN DELAY SLAVE ON OFF 3 M/S PHASE RESET
OFF—ON P/O ADJUST
REVERSE
LOOP
SHADOW
LOOP
EXIT
OPEN
MH3 MH4
REVERSE SHADOW EXIT
FUSE MAX 20A
FUSE MAX 35A
AC POWER SOLAR
24VAC POWER
REVERSE LOOP SHADOW LOOP EXIT LOOP
#1
RELAY LOW CHARGER
BATTERY ON
RELAY
24VDC + –
-24VDC
OPEN
#2 #3 #4 #5 #6 #7 #8 #9 #10 #11
MAG LOCK
STOP POWER 24 VDC
CLOSE
GLOBAL INPUTS OUTPUTS
When ON, Indicates battery pack is connected to operator
and functioning normally.
When ON, Indicates battery charging is taking place.
ON
Power Switch: Connects and
disconnects the AC input power
ONLY.
IMPORTANT:
OPEN OPENING CLOSING CLOSE
LIMIT LIMIT
NOT disconnect battery power to
GATE STATUS
the operator.
20
5-Pin Primary Connector
20 Amp
#12 #13 #14
SLAVE MASTER
+ –
+ – + –
COMM PORT
AC Input Power Wire
Power switch does
21