Service Data - Takeuchi TB108 Operator's Manual

MAINTENANCE

Service Data

Fuel and Lubricant Chart
Use different fuels, lubricants and greases according to the temperature, referring to the
chart below.
¡ Change the lubricant earlier than as shown in the table if it is extremely dirty or its
performance has deteriorated severely.
¡ Whenever possible, use the same brand of lubricant as before. If changing with a different
brand, replace the entire quantity – do not mix different brands.
Part
Diesel
Engine oil
engine oil
pan
API - CD
Hydraulic
Antiwear
tank
hydraulic oil
Diesel fuel
Fuel tank
Coolant
Engine
(water * +
cooling
system coolant **)
Travel
Gear oil
reduction
API-GL-4
gear
Slew motor
pinion
Lithium
Slew
based
bearing
grease
Working
EP-2
equipment
NLGI No. 2
Levers
* For water, use tap water (soft). Do not use well or river water.
** When the ambient temperature drops below 0°C, add coolant (antifreeze). Follow the
coolant manufacturer's instructions to determine the mixture ratio.
Type by temperature
Type
-22 -4 14 32 50 68 86 104
-30 -20 -10 0 10 20 30 40
SAE 5W-20
Use a clean, Quality fuel for good performance and optimum engine life.
¡ To prevent fuel flow problems in cold weather, use diesel fuel with a pour point of
at least -12°C (10°F) below the lowest expected ambient temperature.
¡ Minimum cetane number is 45. Low temperature or high altitude operation may
require the use of fuel with a higher cetane number.
50% coolant mixture
SAE 10W-30
SAE 15W-40
ISO VG32
ISO VG46
ISO VG68
30% coolant mixture
SAE 90
88
Replacement
°
F
interval
°
C
Upper limit:
After first 50
1.7 (1.8)
hrs.
Lower limit:
Every 250 hrs.
1.0 (1.1)
System: 14
(3.7 U.S.gal)
Every 2000 hrs.
Tank: 7.3
(1.9 U.S.gal)
Tank: 8
(2.1 U.S.gal)
Every 1000 hrs. 2.8 (3.0)
After first 250
0.33 (0.35)
hrs.
each
Every 1000 hrs.
Every 50 hrs.
Every 50 hrs.
As
Daily or every required
10 hrs.
When required
Capacity
R(US. qt.)