Every 2000 Hours - Takeuchi TB108 Operator's Manual

MAINTENANCE

Every 2000 Hours

Replacing the Hydraulic Oil and
Cleaning the Suction Strainer
WARNING
¡ ¡ ¡ ¡ ¡ Stop the engine and allow the machine
to cool down before performing
maintenance.
• The engine, hydraulic lines and many
other parts of the machine are hot
directly after the engine is stopped.
Touching these parts will cause
burns.
• The hydraulic fluid is also hot and
under high pressure.
Be careful when loosening caps and
plugs. Working on the machine under
these conditions could result in
burns or injuries due to the hot oil
spurting out.
¡ ¡ ¡ ¡ ¡ Oil may spurt out if caps or filters are
removed or pipes disconnected before
releasing the pressure in the hydraulic
system.
• Gradually loosen the vent plug to
relieve tank pressure.
• When removing plugs or screws or
disconnecting hoses, stand to the
side and loosen slowly to gradually
release the internal pressure before
removing.
1. Slew 45° clockwise and set the machine
to the hydraulic oil level inspection posture.
Refer to page 100 "Inspecting the
Hydraulic Oil Level and Replenishing".
2. Open the engine hood.
7
4
7
3. Loosen the bolts (4) and remove the cover
(5).
4. Slowly turn the vent plug (1) to relieve tank
pressure, then remove.
5. Using a filter wrench, turn the filter (3)
counterclockwise and remove it.
6. Clean the surface of installation of the filter
stand.
7. Apply a thin layer of oil to the packing of
the new filter.
8. Install the new filter by hand.
9. Tighten 3/4 more turns with the filter
wrench after the filter packing comes in
contact with the surface of installation.
10. Place a pan for catching the spent oil
under the drain plug (6).
11. Loosen the drain plug (6) and drain the
hydraulic oil.
12. Loosen the hose clip, then remove the
hoses (7).
13. Remove the bolts, then remove the
flange (8).
14. Remove the suction strainer (9) and
clean it.
15. Clean the inside of the hydraulic tank.
16. Install the suction strainer (9) to the flange
(8).
117
4
1
4
6
5
9
8
B5G0182
2
3