Vidicode V-Tap Manual page 33

Special Tunnel & Network Settings (see also Special Tunnel & Network)
".TS<port>" = Tunnel Source Port 0-32767 (default 0 = random).
".TC<secs>" = Tunnel Connect Timeout (default 22 seconds).
".TI<secs>" = Tunnel Idle Timeout (default 0 = stay always connected).
".TK<secs>" = Tunnel connection Keep-alive Timer value (default 60).
".TV<secs>" = Tunnel Encrypt Vector renewal Timer value (default 15).
".TL<leng>" = Tunnel Minimum Packet Length in bytes (default 60).
".NP<port>"= NTP Port number 0-32767 (default 123, 0=NTP disabled).
".FP<port>" = FTP Port number 0-32767 (default 21 , 0=FTP disabled).
".FT<secs>" = FTP Failure Timeout (default 30 seconds).
".LX<size>" = Maximum Data Size in network packets (default 1024).
".LS<byte>" = Internal network service timer (default 18).
".DT" = Disable Telnet connections.
".DF" = Disable EtherType Filter (default IP & ARP packets only)!
".DB" = Disable Tunnel Filter for Broadcast & ARP packets.
".LD" = Disable disconnecting the Tunnel when a Full-error is detected.
".LH" = Force Half Duplex on all ports, except a split or mirror port.
".LM"= Force 10 Mbps on all ports, except a split or mirror port.
".LG" = Force 100 Mbps on all ports, except split or mirror (VoIP-3 only).
".RT" = VLAN Tags are removed from the Tunnel data and Mirror Port.
".LT" = VLAN Tags are removed from the Mirror Port.
Other Special Settings (debug/test purposes)
".UD" = Disable USB function, so no HID recognition (saves power).
".UP" = Disable USB Pausing (no interrupts 10 minutes after power on).
".UF" = Flash Wait States on 4 (else default on 5).
".UC" = Disable CPU Cash Controller (much slower).
".UM"= Disable Memory Protect Unit (slower).
".LI" = Initialize the IP-stack each time after closing the tunnel.
".LB" = Initialize the IP-stack twice during boot-init.
".LU" = The time is always Daylight Saving Time in NTP function.
".LN" = Disable Daylight Saving Time Correction in NTP function.
".LR" = When DHCP is enabled, a daily reset is done at 03:00.
".VT" = Enable the VLAN table in the switch chip (VoIP-3 only).
".DW"= Disable Workarounds for the switch chip (VoIP-3 only).
".LW<reg>=<val>" = Write a register in the switch chip with a value.
".MAC<hhhh>" = MAC Configuration bits (4 hex digits, default C254).
".I2C<num>" = I2C interface speed 160/8*num (default 50 = 400 KHz).
".XO" = Debug mode enabled. Output to the serial port (57600,n81).
".XF" = Open debug trace file. The file is closed after a new login. Then
".XF" must be removed again and the settings saved. The file
TRACE.TXT can be downloaded with ftp or read from the card.
V-Tap VoIP Manual EN v3.23 Aug 2021 © 2017-2021 Vidicode 33