Table of Contents
Advertisement
24
RC3050 Antenna Controller
3.2.3 Waveguide Mode
The optional WAVEGUIDE mode allows the user to change the position of a waveguide switch.
POS:
This field shows the currently sensed position of the waveguide switch. "H" denotes the horizontal
position, "V" the vertical, "?" indicates that neither position is sensed and "*" indicates that both H and V
are sensed (probably an error condition).
Pressing the Fast/Slow button will toggle the switch position. During the switch transition, a "+" will be
displayed when going to the H position and a "-" will be shown while going to the V position. Note that
after 5 seconds the switching operation will timeout and drive voltage will be stopped if the desired
position has not been sensed.
Research Concepts, Inc.; 5420 Martindale Road; Shawnee, Kansas 66218-9680 USA
POS:H
WAVEGUIDE
<F/S>TOGGLE POS
24
Chapter 3
Detailed Operation
www.researchconcepts.com
Advertisement
Table of Contents
