Installation - RESEARCH CONCEPTS RC3050 User Manual

8 RC3050 Antenna Controller
Proper installation is important if the full capability and accuracy of the RC3050 is to be realized. The
procedures that follow will insure the optimum level of performance from all sensors and the system in
general. Prior to installation, please review section 1.3.2 (System Interface Requirements) to verify the
correct system interfaces are provided.
Installation will be more efficient if each step in the physical installation and calibration be performed in
the order in which it appears in the following schedule. Each step is referenced to a particular section of
this manual, and should be checked off as it is completed.
The installation procedures are written to cover the most common mount installations. Some steps are
slightly different according to the type of mount the RC3050 is interfacing to. Please review appendix A
now for differences applicable to your mount.
SECTION ACTION
2.1.1 RC3050 Antenna Controller
2.1.2 Inclinometer
2.2.1 Power Entry
2.2.2 Motor Drive
2.2.3 Drive Sense
2.2.4 Limit Switches
2.2.5 Waveguide Switch
2.2.6 Hand Held Remote
2.3.1 Version Verification
2.3.2 Drive and Sensor Polarity
2.3.3 Position Sensor Rigging
2.3.4 Azimuth and Elevation Limits
2.3.5 Fast/Slow Motor Speed
2.3.6 Drive System Checkout
Installation requires basic operational knowledge of the RC3050. Please review chapter 3 for
information on how to navigate the RC3050's screens.
Research Concepts, Inc.; 5420 Martindale Road; Shawnee, Kansas 66218-9680 USA

2.0 INSTALLATION

2.1 Equipment Mounting
2.2 Electrical Connections
2.3 Calibration
8
Chapter 2
COMPLETE
Installation
www.researchconcepts.com