Appendix A - Mount Specific Data - RESEARCH CONCEPTS RC3050 User Manual

40 RC3050 Antenna Controller
APPENDIX A – MOUNT SPECIFIC DATA
Mount Variations
The following table lists the different mounts supported by the RC3050 and the required software model
number required to support that mount.
MODEL # MOUNT
V1 2.4 m. DMK
V2 1.5 m. SMK
V3 2.6 m. DMK
V4 1.2 m. SMK
All Vertex mobile mounts supported by the RC3050 use 90 VDC motors thus requiring the RC3050B
hardware configuration.
System Interfaces
All Vertex mounts provide the basic RC3050 interface requirements. Azimuth stow and elevation UP,
DOWN and STOW limit switches are provided.
Sensor Rigging and Calibration
To calibrate all Vertex models, the front of the dish should be placed in the vertical position.
MODEL #
V1
V2
V3
V4
V5
V6
V7
V8
Research Concepts, Inc.; 5420 Martindale Road; Shawnee, Kansas 66218-9680 USA
Appendix A
For
VERTEX SMK / DMK
MODEL # MOUNT
V5 1.5 m. SMK-
LT
V6 N/A
V7 1.2 m. SMK-
LT
V8 1.8 m. SMK-
LT
RF Boresite Angle
22.3
15.8
22.3
12.8
15.8
N/A
12.8
18.5
40
Mount Specific Data
Target Inclinometer Voltage
1.69
1.69
1.69
1.69
1.69
N/A
1.69
1.69
www.researchconcepts.com