Table of Contents
Advertisement
Page 50
To turn a point OFF, perform the following procedure.
1. Ensure the point to be turned OFF is shown on the alphanumeric display. A typical
point (2:SIG3) is shown below.
4TH FLOOR - EAST WING - STROBES
VISUAL
2. Press the <OFF> key. A typical display is shown below.
Press <ENTER> to force OFF
SIGNAL CIRCUIT: 2:SIG3
3. Press the <ENTER> key. A typical display is shown below.
4TH FLOOR - EAST WING - STROBES
VISUAL
4. Press the <FLT ACK> key.
5. Press the <CLR> key. The display shows the following message.
** FAULT **
ALARMS=0
7.3
HOW TO TURN A POINT ON
The <ON> key press will turn a control point ON and prevent the automatic operation by
increasing its priority, causing it to remain ON. With the exception of pseudo points, this
action will result in a system fault. The normal state of all control points is AUTO. The
<ON> key press has no effect on monitor points.
The point to be turned <ON> must first be identified to the system. This is accomplished by
selecting/entering the identity of the required point on the alphanumeric display, and
pressing the <ON> key. If the <ON> key is passcode protected, perform the system Log In
Procedure.
To turn a point ON, perform the following procedure.
1. Ensure the point to be turned ON is shown on the alphanumeric display. A typical
point (2:SIG3) is shown below.
4TH FLOOR - EAST WING - STROBES
VISUAL
Document No.: 4100-M004
SIMPLEX 4120 NETWORK FIRE INDICATOR PANEL
Press <ACK> to review.
ISOLATES=0
June 1997
OPERATOR MANUAL
ON
OFF
FAULTS=1
OFF
Issue 1.0
Advertisement
Table of Contents
