Table of Contents
Advertisement
SIMPLEX 4120 NETWORK FIRE INDICATOR PANEL
OPERATOR MANUAL
After a brief pause, the display shows the granted access level, such as level 3 access
message shown below.
F1=Login
CURRENT ACCESS LEVEL = 3
7.
Press <CLR> key on the ENTRY keypad twice. The display shows system status, as
shown below.
SIMPLEX AUSTRALIA SYSTEM IS NORMAL
1.3.1.2 Access Level Log Out Procedure
FAILURE TO LOG OUT ALLOWS UNAUTHORISED PERSONNEL ACCESS TO THE
VARIOUS PASSCODE PROTECTED FUNCTIONS.
DETECTED FOR TEN MINUTES, THE SYSTEM WILL RETURN TO LEVEL 1 ACCESS.
To Log out, perform the following procedure.
1.
Press the <MENU>key on the DISPLAY/ACTION keypad.
2.
Press the <NEXT> key until the menu prompt "CHANGE ACCESS LEVEL?" appears
on the alphanumeric display.
3.
Press <ENTER> on the ENTRY keypad.
4.
Press the <F2> key (above the alphanumeric display) to Log Out.
5.
Press the <CLR> key on the ENTRY keypad to escape from the Main Menu.
1.3.2 HANDLING ABNORMAL CONDITIONS
If an abnormal condition occurs, at least one of the LEDs (alarm, isolate or fault) will start
flashing, and the tone-alert will sound. The panel will display the total number of abnormal
conditions present in the system. At a glance, the user knows how serious the situation
might be by reading the number of abnormal conditions displayed, such as the single alarm
shown below.
ALARMS = 1
Document No: 4100-M004
F2=Logout
08:23:43
IMPORTANT
***ALARM***
ISOLATED = 0
MON 25 JAN 95
IF NO KEYPAD ACTIVITY IS
Press ACK to review.
FAULT = 0
June 1997
Page 7
Issue 1.0
Advertisement
Table of Contents
