Table of Contents
Advertisement
Dimensional function Keys
Millimeters — Identifies entry as millimeters, with
m
repeated presses toggling between linear, area and
volume units. Converts dimensional value to units of
millimeters, with repeated presses toggling between
millimeters and meters.
centimeters (cm) — Identifies entry as centimeters,
g5
with repeated presses toggling between linear, area
and volume units.
Meters (m) — Identifies entry as meters, with
g9
repeated presses toggling between linear, area and
volume units.
Feet — Identifies entry as Feet, with repeated
g7
presses of
volume units. Also used with
Feet-Inch values. Repeated presses of
conversions toggle between fractional Feet-Inch and
decimal Feet.
Inch — Identifies entry as Inches, with repeated
i
presses toggling between linear, area and volume
units. Entry can be whole or decimal numbers. Also
used with
9i1/2
toggle between fractional and decimal Inches.
Fraction bar — Used to enter fractions. Fractions
/
can be entered as proper (1/2, 1/8, 1/16) or improper
(3/2, 9/8). If the denominator (bottom) is not
entered, the calculator's fractional accuracy setting
is automatically used. Results are always shown in
typical dimensional fractional format.
toggling between linear, area and
g7
for entering fractional Inch values (e.g.,
/
). Repeated presses during conversions
and
for entering
i
/
g7
U
'
ser
s
during
(cont'd)
G
— 5
Uide
Advertisement
Table of Contents
