Table of Contents
Advertisement
(cont'd)
M- — Subtracts displayed value from Accumulative
g M
Memory.
Dimensional function Keys
Millimeters — Identifies entry as millimeters, with
m
repeated presses toggling between linear, area and
volume units. Converts dimensional value to units of
millimeters, with repeated presses toggling between
millimeters and meters.
centimeters (cm) — Identifies entry as
g 5
centimeters, with repeated presses toggling
between linear, area and volume units.
Meters (m) — Identifies entry as meters, with
g 9
repeated presses toggling between linear, area and
volume units.
Feet — Identifies entry as Feet, with repeated
g 7
presses of
volume units. Also used with
Feet-Inch values. Repeated presses of
conversions toggle between fractional Feet-Inch and
decimal Feet.
Inch — Identifies entry as Inches, with repeated
i
presses toggling between linear, area and volume
units. Entry can be whole or decimal numbers. Also
used with
9i1 / 2
toggle between fractional and decimal Inches.
Fraction bar — Used to enter fractions. Fractions
/
can be entered as proper (1/2, 1/8, 1/16) or
improper (3/2, 9/8). If the denominator (bottom) is
not entered, the calculator's fractional accuracy
setting is automatically used. Results are always
shown in typical dimensional fractional format.
6 — M
achinist
g7
for entering fractional Inch values (e.g.,
/
). Repeated presses during conversions
c
P
alc™
ro
toggling between linear, area and
i
and
for entering
/
during
g7
Advertisement
Table of Contents
