Front Panel - Enterasys Vertical Horizon VH-2402S2 Hardware Installation Manual

Front Panel

Figure 1-1 shows the front panel of the Enterasys Networks Vertical
Horizon VH-2402S2. Table 1-1 defines the VH-2402S2 front panel
components.
10/100M RJ-45 Ports
Name
Power LED
RDP LED
Mgmt LED
Link LEDs
Mode LEDs
Module LEDs
Switch ID LCD
10Base-T/100Base-TX
RJ-45 ports
4 Product Overview
Port Status Indicators
Mode - Flow control, duplex, activity
Link - On: link/enable; Off: no link;
Figure 1-1. VH-2402S2 Front Panel
Table 1-1. Front Panel Components
Function
Lights steady green to indicate power is supplied to the
switch. Off indicates no power is supplied to the switch.
Lights steady to indicate that a redundant power unit is
attached and is in backup or active mode.
Lights steady to indicate that a Management Module is
installed and in operational mode.
Yellow indicates a 10 Mbps link; green indicates a 100
Mbps link, off indicates no link; and flashing indicates
that the port has been manually disabled.
The Mode Select button selects the LED display mode.
Act: Flashing indicates activity on the port segment.
FDX: Lights steady to indicate full-duplex operation.
Flow Ctrl: Lights steady to indicate that flow control is
enabled for the port.
Status: Indicates a module is installed in the slot.
Activity: Flashing indicates activity on the module.
LCD displays the stack ID number of the switch.
Copper ports using RJ-45 port connectors. All the ports
are wired MDI-X.
Flashing: disable
Mode Selection
Flow control, duplex, activity
System Indicators
Power, redundant power, management
VH-2402S2