Network Requirements; Smarttrunk Feature; 1000Base-T Network (Fixed Front Panel Ports) - Enterasys SmartSwitch 6G302-06 Installation Manual

Enterasys smartswitch 6g302-06: install guide

Hide thumbs Also See for SmartSwitch 6G302-06:

Errata (1 page)

Table Of Contents

Table of Contents

Before installing the module, review the requirements and specifications referred to in this chapter

concerning the following:

• SmartTrunk

(Section

• 1000BASE-T

(Section

• 1000BASE-SX/LX

The network installation must meet the requirements to ensure satisfactory performance of this

equipment. Failure to do so will produce poor network performance.

NOTE: The Matrix E7 Series and SmartSwitch 6000 Series Modules Local

Management User's Guide referred to in the following sections can be found on the

Enterasys Networks World Wide Web site:

2.1

SMARTTRUNK FEATURE

Before connecting the module to a network so it can take advantage of the SmartTrunk feature,

there are certain rules concerning port connections and configurations that must be followed for

proper operation. Refer to the Matrix E7 Series and SmartSwitch 6000 Series Modules Local

Management User's Guide for additional information.

2.2

1000BASE-T NETWORK (FIXED FRONT PANEL PORTS)

The fixed front panel ports on the 6G302-06 module provide copper wire connections that can

operate at 1000 Mbps (1 Gbps) and are 1000BASE-T compliant. The device at the other end of the

copper connection must also meet the 1000BASE-T Gigabit Ethernet requirements for the devices

to operate at Gigabit speed.

2.1)

2.2)

(Section

2.3)