WARNING: Only qualified personnel should install the 6G302-06 or 6G306-06.
NOTE: Read the Release Notes shipped with the module to check for any exceptions to
the supported features and operation documented in this guide.
Unless otherwise noted, the following instructions apply to both the 6G302-06 and
6G306-06.
This chapter provides the instructions to install the 6G302-06 and 6G306-06. A Phillips
screwdriver is required to install options into the module. Follow the order of the sections listed
below to correctly install the module.
• Unpacking the Module
• Installing Options into the 6G306-06
• Installing the Module into the Matrix E7 Chassis
• Installing the Module into the SmartSwitch 6000 (6C105) Chassis
• Connecting the 6G302-06 to the Network
• Connecting the 6G306-06 to the Network
• Completing the Installation
(Section
3.1)
(Section
(Section
(Section
(Section
3.7)
3.2)
(Section
3.3)
3.5)
3.6)
Installation
(Section
3.4)
Installation
3
3-1