Remote Hydraulic Valve Requirements; Tractor Drawbar; Tractor Pto; Tire Inflation - MASSEY FERGUSON 9516 Service Manual

Planter
Table of Contents

Advertisement

Remote Hydraulic Valve Requirements

Three remote valves are required:
1. One valve controls the frame lift/lower circuit.
2. A
second
valve
height/marker/fold circuits.

Tractor Drawbar

Adjust tractor drawbar to between 36 cm (14 in) and 51
cm (20 in) off the ground and position so hitch pin hole is
36 cm (14 in) from the end of the PTO shaft.

Tractor PTO

The planter hydraulic pump requires a 1000 rpm tractor
PTO shaft of either size:

Tire Inflation

Inflate tires as recommended in tractor operator's manual.

Front Weights

Install as many weights as required for front end stability
when planter is folded. Also refer to the tractor operator
manual.

Electrical Requirements

The tractor electrical system must provide 12 volts D.C. to
operate the seed monitor, highway lighting system, frame
fold control system, and hydraulic seed drive controller.

PLANTER PREPARATION

Lubrication

Lubricate the planter as required. Also, check the fluid
level in the PTO pump. Add fluid if required.

Bolt Torque

Tighten all bolts according to the chart.
Tire Inflation
See Specifications for the correct tire pressure.

Markers

Adjust markers to correct length.

Chains

Make sure all drive chains are installed with the proper
tension, alignment, and lubrication.

Seed Discs

Install the correct seed discs in all of the metering units.
4283529M1
controls
the
tongue
Field Operations and Adjustments
3. A third valve will be needed for hydraulic drive and
singulation blowers if the PTO pump is not used.
Minimum available tractor system pressure must be
15,502 kPa (2250 psi).
IMPORTANT: Drawbar must be in shortest possible
position.
IMPORTANT: Tractor must be equipped with heavy duty
drawbar option from tractor manufacturer.
21-spline, 1-3/8 inch diameter
20-spline, 1-3/4 inch diameter
IMPORTANT: Connect electrical equipment only to 12
volts DC.
The transport lighting system is connected to the tractor
with a standard 7-pin connector.
Make sure all bolts, nuts, and screws are tight and all
cotter pins are spread.
Adjust the seed gates as needed.
01-17

Advertisement

Table of Contents
loading

This manual is also suitable for:

952395249531

Table of Contents