Field Operations and Adjustments
Hydraulic Seeding Monitor
Program the ISOBUS planter controller for the crop to be
planted. Make sure the radar devise is in the correct
position.
PLANTER CONTROLS
Mount the ISOBUS planter controller console in suitable
cab location. Connect the input leads of the monitor to the
12 VDC battery terminals.
NOTE: The ISOBUS planter controller console does not
have to be mounted on the level to operate
properly.
For convenience:
•
Mount implement switch on lever controlling planter
raise-lower hydraulic circuit.
•
Mount frame control box where folding and unfolding
procedures can be observed while using the box.
NOTE: The dealer must have installed all electrical
controls in the tractor cab.
Route the output wire harnesses to the rear of the tractor.
01-18
4283529M1