Table Of Contents; Maxdata - Cabletron Systems SmartSwitch 1800 User Manual

PU Configuration Panel
Configurable Parameters
ISTATUS

MAXDATA

REPLYTO
8
Moving the cursor to a parameter and pressing a supported function key gives you
these additional options:
- will allow you to change the configured values of the
[PF6] Modify
parameter, if the parameter is displayed in green.
- will activate the line.
[PF7] Activate
- will de-activate the line.
[PF8] Deact
- will display output from the runcmd.
[PF10] Display
- will re-display the screen with updated values.
[PF11] Refresh
S ervice Point: BD0N VSP
Line name: LIN E11
A ctu al Statu s: AC TIV
PF 1-Help 2-Exit 3-En d 4-PD S tats 6-Modify 7-Act 8-Deact 10-D is play 11-Refresh
S DLC
S DLC Ad dres s
I STATU S
MAX DATA
MAX OU T
MODULO
D ATMOD E
R EPLY TO
R ETRIES
LPDS RESI D
A UTOCALL
A uto Retry Tout
A uto Retry Ct
Local S ub
R emote Sub
will cause the PU to be enabled (if
is activated. The PU will remain in that state until either an on-line SDLC PU disable
or enable is performed on the Cabletron device (as described in the User Guide) or a
or
VARY INACT VARY ACT
is equivalent to the Cabletron device parameter
values are .
25-4105
is equivalent to the Cabletron device parameter
between polls by the TPAD port of its PU when the PU is not responding. The TPAD
will continue to poll at this interval up to the number of times specified by
PU Lin e Configuration Panel
PU Name: PUC3
Desired S tatu s: AC TIV
LLC2
C3 Respon se Timer (T1)
ACTI V Ack Timer (T2)
265 Inactivity Timer (Ti)
See Line Con fig LANI N (N3)
See Line Con fig LANOUT (Tw)
HA LF retries (N2)
1.0 Bandw id th Allocation (BA G)
See Line Con fig
80
ENABLE Local SAP
60 Local MA C A ddress
00 PU Typ e
1123
2223
Figure 6 PU Configuration Panel
) or disabled (if
ACT
is sent from the NetVIEW manager.
Vers ion : 3200|
10
100
30
001
001
008
00
04
4000000000C3
LLC 2
) the next time the line
INACT
Maximum Bytes per Frame
, which is the time
No Resp Poll Period
NetView Service Point
. Valid
RETRIES