Power Supply Installation - Enterasys RoamAbout AP-2000 Hardware Installation Manual

Power Supply Installation

Power Supply Installation
To install the 100-240 Vac power supply, perform the following steps:
1. Verify that you have the correct power supply connector.
2. Insert the appropriate connector into the power supply.
2-6 Cabling and Wiring
Caution: Do not connect the power supply to the primary source until instructed to do
so.
Precaución: No conecte la fuente del poder a la fuente primaria hasta que no se le
indique.
Caution: You must use a UL Listed Class 2 power supply. Refer to the power supply
specifications in this document.
Precaución: Debe utilizarse una fuente de poder de clase 2 con certificación
UL. Remítase a las instrucciones de la fuente que figuran en este documento.