Enterasys RoamAbout AP-2000 Hardware Installation Manual page 44

Surface Wallmount Installation
8. If you install the optional Dual Band Range Extender
antenna or the outdoor antenna:
a.
b. Insert the antenna cable connector into the radio card
c.
9. Install the remote power injector or the rack mount kit, if
used. Refer to
page 2-3 or the
page 2-5.
Connect the output of the remote power module to the PWR jack on the remote power
injector.
10. Connect the 10BaseT/100BaseT Ethernet
network cable.
• If you are using the remote power feature,
• If you are not using remote power, install the
11. Connect the power module into an AC outlet.
3-12 Installing the RoamAbout R2
Remove the dust cover from the radio card
connector.
connector.
Gently press down on the cable connector to secure
the antenna connection.
Note: If you are using the RoamAbout R2 with the
mezzanine option, one of the cards must be connected to
the Range Extender antenna to prevent radio interference
between the two cards.The antenna must be placed at
least two feet away from the RoamAbout R2.
"Remote Power Injector Installation"
"Rack Mount Kit Installation"
label the end of the cable to the RoamAbout
R2 with: CAUTION: Ethernet cable contains
power. Do not use for other devices.
power module/redundant power module, if
used; refer to "Power Supply Installation"
page 2-6.
on
on
on