Enterasys RoamAbout AP-2000 Hardware Installation Manual page 28

Remote Power Injector Installation
To install the remote power injector, perform the following steps:
1. Use a cable tester to check the cable wiring to the RoamAbout R2. Check the
continuity and pairing.
2. Select a mounting location:
–
–
3. Secure the remote power injector.
If necessary, use the two wall anchors
provided in your installation kit.
4. Insert the Ethernet cable connector into the
Network jack.
5. Insert the RoamAbout R2 cable connector into
the RoamAbout AP jack.
6. Proceed to
2-4 Cabling and Wiring
Close to the Ethernet wiring panel or Ethernet port.
Within six feet of an AC power outlet (if remote power is used).
Chapter 3.