4
Making Network Connections
Table 4-3. Maximum 1000BASE-LX Gigabit Ethernet Cable Length
Fiber Size
9/125 micron
single-mode fiber
Table 4-4. Maximum 1000BASE-LH Gigabit Ethernet Cable Length
Fiber Size
9/125 micron
single-mode fiber
100 Mbps Fast Ethernet Collision Domain
Type
100BASE-TX Category 5 or better 100-ohm UTP or STP 100 m (328 ft)
100BASE-FX
Multimode
100BASE-FX
Single-mode
10 Mbps Ethernet Collision Domain
Cable Type
Twisted Pair, Category 3 or better 100-ohm UTP
Cable Labeling and Connection Records
When planning a network installation, it is essential to label the opposing ends of
cables and to record where each cable is connected. Doing so will enable you to
easily locate inter-connected devices, isolate faults and change your topology
without need for unnecessary time consumption.
To best manage the physical implementations of your network, follow these
guidelines:
• Clearly label the opposing ends of each cable.
• Using your building's floor plans, draw a map of the location of all
network-connected equipment. For each piece of equipment, identify the devices
to which it is connected.
• Note the length of each cable and the maximum cable length supported by the
switch ports.
4-6
Fiber Bandwidth
N/A
Fiber Bandwidth
N/A
Table 4-5. Maximum Fast Ethernet Cable Lengths
Cable Type
50/125 or 62.5/125 micron core multimode
fiber (MMF)
9/125 micron core single-mode fiber (SMF) 20 km (12.43 miles)
Table 4-6. Maximum Ethernet Cable Length
Maximum Cable Length
2 m - 5 km (7 ft - 3.2 miles) LC
Maximum Cable Length
2 m - 70 km (7 ft - 43.5 miles) LC
Max. Cable Length
2 km (1.24 miles)
Maximum Length
100 m (328 ft)
Connector
Connector
Connector
RJ-45
SC
SC
Connector
RJ-45