Side Clip Gpims; Installing The Side Clip Gpim - Enterasys Matrix E5 5H152-50 Installation Manual

Figure 3-3 Different Physical Styles of GPIMs
➀
Side clip
After installing a GPIM, refer to
3.3.1

Side Clip GPIMs

This section applies only to side clip GPIMs. Damage can result to the GPIM and host 5PIM if the
directions in this section are not followed carefully.
Refer to Appendix C
CAUTION: The GPIM, 5PIM, and module are sensitive to static discharges. Use an
antistatic wrist strap and observe all static precautions during this procedure. Failure to
do so could result in damage to the GPIM, 5PIM, or module. Always leave the GPIM in
the antistatic bag in which it was shipped or an equivalent antistatic container until ready
to install it.
3.3.1.1

Installing the Side Clip GPIM

To install the GPIMs, refer to
1. Attach the antistatic strap (refer to the instructions in the antistatic wrist strap package) before
removing the GPIM from the antistatic packaging.
2. Remove the GPIM
À
Section 3.6
for cable specifications for the GPIMs.
Figure 3-4
➀
from the packaging.
Á
➁
Locking bar
for details on connecting the GPIM to the network.
and proceed as follows:
Installing Optional GPIMs
3-7