Table of Contents
Advertisement
Parameter
Enable
Working Period
Anti-Dither
VMD area
Record
Record Delay
Relay out
Alarm Delay
Send Email
PTZ
Snapshot
Set working period.
Click "Setup", and it will display the interface of working period. See Figure 7-33.
You need to check the box to enable VMD function.
Here you can set arm/disarm period. Click on the [Setup] button to open period
setup menu.
There are six periods every day for setup and you must check box in front of each
period to enable it.
Note: Period setup can be done by dragging mouse while not release left mouse.
System only memorizes one event during the anti-dither period. The value ranges
from 0s to 100s.
Here you can set motion detection region and its sensitivity and area. (The higher
the sensitivity is, the easier to trigger motion detect; the smaller the area, the
easier to trigger motion detect.) The default covers all regions. You must click on
the [Save] button before enabling your setup.
Check it and so when VMD occurs, system will auto record. You shall set record
period in Storage>Schedule and select auto record in record control interface.
System can delay the record for specified time after alarm ended. The value
ranges from 10s to 300s.
Enable alarm activation function. You need to select alarm output port so that
system can activate corresponding alarm device when alarm occurs.
System can delay the alarm output for specified time after alarm ended.
The value ranges from 10s to 300s.
If you enabled this function, System can send out email to alert you when alarm
occurs and ends.
Here you can set PTZ movement when alarm occurs. Such as go to preset x when
there is an alarm.
The event type includes: preset, tour and pattern.
You need to check the box here so that system can backup VMD
snapshot file.
Function
53
Advertisement
Table of Contents
