Troubleshooting - Bush Hog DHP8 Operator's Manual

Arrange the chains so that when tightened, the
chains are pulling
themselves. Carefully tighten the securing chains or
other fasteners using boomers or binders to apply
maximum tension. Use extreme care when attaching
and removing the securing devices as the extreme
tension involved when released has the potential to
inflict serious injury.
While hauling the tractor and implement, make
occasional stops to check that the tractor and
implement have not moved or shifted and that the
securing chains have maintained tension. If during
transport a hard braking, sharp turning, or swerving
action was performed, stop at the next safe location
to inspect the security of the load. OPS-U- 0026

15. TROUBLESHOOTING

Problem
Disc Harrow makes a high
center ridge.
Disc Harrow cuts a furrow
soil to the center.
DHP8, DHP10, DHP12
© 2021 Alamo Group Inc.
OPERATION
downward and against
Possible Cause
Disc Blades are not moving enough
soil to the center.
Disc Blades are not moving enough
turning spring adjuster clockwise.
05/21 Operation Section 4-24
Remedy
Tilt Disc Harrow up at the rear by
turning spring adjuster counterclock-
wise. See "Front to Rear Leveling".
Set Tractor drawbar in its lowest
possible position by flipping the offset
drawbar over.
Decrease tractor speed.
Increase spacing between disc gangs
by moving all gang hangers on both
sides away from the center by equal
amounts.
Tilt Disc Harrow down at the rear by