Contec Conprosys CPS-MC341-ADSC1-111 Reference Manual page 73

CPS-MC341-ADSC1-111, CPS-MC341-ADSC2-111, CPS-MG341-ADSC1-111 Reference Manual (Hardware)
Item
Parity check
The number of channels
Connector
LED
Digital input/ Input type
Counter input
Isolation/Resistance
Built-in power supply
Input resistance
Input ON current
Input OFF current
Response time
Interrupt (Digital input)
The number of channels
Count type
Max. count
Counter response speed
Interrupt (Counter input)
Timer
LED
Surge protection element
each signal to B_COM
Digital output Output type
Isolation/Resistance
Maximum output voltage /
current
Response time
ON resistance
OFF leakage current
The number of channels
LED
Surge protection element
+ to -
Digital input / Connector
Counter input /
Digital output
Applicable wire
— —
Appendix
CPS-MC341-ADSC1-111
CPS-MG341-ADSC1-111
Even, Odd, Non-parity
1
9-pin D-SUB connector (Male)
Transmission (Yellow), Reception (Yellow)
Opto-coupler Isolation Input (Compatible with current sink
output and current source output) (negative logic) *1
Bus Isolation /500VDC, Opto-coupler Isolation/1000V
12VDC
5.6kΩ
1.6mA or more
0.16mA or less
Within 200μsec *2
4 interrupt input signals are arranged into a single output of
interrupt signal. An interrupt is generated at the falling edge
(HIGH-to-LOW transition) or rising edge (LOW-to-HIGH
transition). (setting can be done by software)
4 (It is possible to allocate 2channels to counter input)
Up count
FFFFFFH (binary data)
1kHz (Max.), Duty: 50% (Max.)
One interrupt caused upon channel count match
None
DI0 - DI3 (Yellow)
Interactive TVS diode
Stand off voltage : ±30V, Peak pulse power : 400W(1msec)
Semiconductor relay output
Semiconductor relay isolation/1000V
26.4VAC/VDC/100mA
Within 2msec
8Ω or less (at 25℃)
4μA or less (at 25℃)
2
DO0 - DO1 (Yellow)
Interactive TVS diode
Stand off voltage : ±30V, Peak pulse power : 400W(1msec)
2-piece 3.5mm pitch 10-pin terminal
(DI_ACOM, DI0, DI1, DI2, DI3, DI_BCOM, DO0+,
DO0-, DO1+, DO1-)
AWG28 - 16
— 73 —
CPS-MC341-ADSC2-111