Chapter 4 General Wiring; Components Introduction; Wiring Electric Supply - HIKVISION DS-K3G411 Series Quick Start Manual

DS-K3G411 Series Tripod Turnstile Quick Start Guide

Chapter 4 General Wiring

4.1 Components Introduction

By default, basic components of the turnstile are connected well. The turnstile supports wiring the
AC electric supply for the whole system's power supply.
Note
The voltage fluctuation of the electric supply is between 100 VAC and 220 VAC, 50 to 60 Hz.
The picture displayed below describes each component's position on the turnstile.
Figure 4-1 Components Diagram 1

4.2 Wiring Electric Supply

Wire electric supply with the switch in the pedestal. Terminal L and terminal N are on the switch,
while terminal PE should connect to a ground wire (yellow and green wire).
9