Chapter 2 System Wiring - HIKVISION DS-K3G411 Series Quick Start Manual

DS-K3G411 Series Tripod Turnstile Quick Start Guide
The preparation before installation and general wiring.
Steps
1. Draw a central line on the installation surface of the left or right pedestal.
2. Draw other parallel lines for installing the other pedestals.
Note
The distance between the nearest two line is 581+200 mm. L represents the lane width.
3. Slotting on the installation surface and dig installation holes according to the hole position
diagram.
4. Bury cables. Each lane buries 1 network cable and 1 high voltage cable. For details, see the
system wiring diagram below.

Chapter 2 System Wiring

Figure 2-1 Hole Position Diagram
Figure 2-2 System Wiring Diagram
3