Table of Contents
Advertisement
DS-K3G501LX Series Tripod Turnstile User Manual
Chapter 4 General Wiring
4.1 Components Introduction
By default, basic components of the turnstile are connected well. The turnstile supports wiring the
AC electric supply for the whole system's power supply.
Note
The voltage fluctuation of the electric supply is between 100 VAC and 240 VAC, 50 to 60 Hz.
The picture displayed below describes each component's position on the turnstile.
Figure 4-1 Components Diagram
4.2 Wiring Electric Supply
Wire electric supply with the switch in the pedestal. Terminal L (brown) and terminal N (Blue) are
on the switch, while terminal PE should connect to a ground wire (yellow and green wire).
For product with switching power supply, the wiring diagram is as follows:
9
Advertisement
Table of Contents
