Wire Network Switch - HIKVISION DS-K3G411 Series Quick Start Manual

DS-K3G411 Series Tripod Turnstile Quick Start Guide
Warning
Terminal PE should connect to a ground wire to avoid hazard when people touching the device.
Note
• The cable bare part should be no more than 8 mm. If possible, wear an insulation cap at the end
of the bare cable. Make sure there's no bare copper or cable after the wiring.
• The Terminal L and the Terminal N cannot be wired reversely. Do not wire the input and output
terminal reversely.
• To avoid people injury and device damage, when testing, the ground resistance of the
equipotential points should not be larger than 2 Ω。

4.3 Wire Network Switch

Connect the network cable and the network switch.
Steps
1. Use the key to open the side panel of the pedestal.
10