HIKVISION DS-K3G411 Series Quick Start Manual page 27

DS-K3G411 Series Tripod Turnstile Quick Start Guide
Interface Name
RS-485C/RS-232C
Terminal Name
GND
485C+
485C-
GND
Description
Terminal Accessing
(Default)
Grounding
RS-232_RX Terminal of
Fingerprint Recorder
Accessing (Default)
RS-232_TX Terminal of
Fingerprint Recorder
Accessing (Default)
Grounding
16
Remark
is for entering, and
4 is for exiting.
• If the visitor card is
configured, you
should wire two
card readers for the
exiting side. One's
DIP address is 4,
and the other is 3.
Card Reader 3 can
be applied together
with the card
receiver. The normal
user can
authenticate on
Card Reader 4 and
the visitor can
authenticate on
Card Reader 3.
• You can switch the
communication
mode between
RS-485 and RS-232.
For details about
the DIP switch
description, see
Main Control Board
DIP Switch
Description
Note
• The DIP of RS-485
card ID is set as 1
and 4 by default. 1
is for entering, and
4 is for exiting.
• If the visitor card is
configured, you
should wire two
card readers for the
exiting side. One's