Table of Contents
Advertisement
Field Service Procedure – Replacement PCU Kit, ST88, ST94 & ST144
16.
Modem Query Methods:
The following text provides instruction on how to submit modem queries using any one of four different methods as
listed below. These instructions assume that the operator have a clear understanding of Menu navigation and entry via
the Antenna Control Unit front panel, or connection requirements for using remote diagnostic software, and/or the
internal HTML page of the ACU. Refer to the appropriate manual text if further instruction on wiring connections or
button pushing is required.
16.1.
Using the ACU Front Panel:
1.
Using the ACU's front panel, navigate through
the setup menu to access the remote
command sub‐menu.
2.
Enter in the desired modem query then press
the enter key.
3.
Observe and/or record the displayed response.
16.2.
Using the Internal HTML Page:
1.
Logon to the ACU's internal HTML
page.
2.
Browse to the "communication port
settings" page.
3.
In the command window, type in the
desired modem query and hit send.
4.
Observe and/or record the displayed
response.
5.
Repeat as required until all desired
modem queries are noted.
Page 9 of 22
Copyright © Sea Tel, Inc 2012 - The information contained in this document is proprietary to Sea
Tel, Inc. This document may not be reproduced or distributed in any form without prior written
consent of Sea Tel, Inc.
Document No
137738 Rev A
Advertisement
Table of Contents
