Advertisement
Available languages
Available languages
•
Function "Auto clean":
This function is used to automatically clean your appliance. Press the
"Auto clean" button (D). Do not exceed 1 litre of hot water (maximum
temperature of 80°C / 176°F). At the end of the program, the appliance
stops automatically and you hear 4 beeps.
WARNING : If the load becomes too high, your appliance will stop
•
automatically for safety reasons (if the motor runs for more than 3
minutes or if you have used too much ingredients). To restart your
appliance, turn the control knob to
and can be up to 30 minutes. Before restarting your appliance, adapt the
quantity of ingredients or blending time to avoid any overload. You can then
select the desired speed or function to complete your preparation.
WARNING : Do not use the program functions smoothie, ice crush
•
and auto clean with the herb chopper (K) and spice grinder (L). These
programs can only be used with the blender jug (F). Do not perform ice
crush with the herb chopper (K) and spice grinder (L).
USING THE HERB CHOPPER (K) AND SPICE GRINDER (L)
(depending on model)
With the herb chopper (K) you can chop ingredients like onions, garlic or
-
raw meat (pre-cut into small pieces) in a few seconds. Do not use the herb
chopper for liquid preparations (fruit juices, etc.).
With the spice grinder (L) you can grind spices in a few seconds: coriander
-
seeds, peppercorns, etc.
These accessories are equipped with a bowl (M) that prevents access to
-
the blades during use.
1. Turn the bowl (M) upside down and add the ingredients.
2. Position the seal (K1 or L1) in its recess on the blade unit (K2 or L2) (Fig.
5). Position the blade unit on the bowl. Lock the accessory by rotating the
blade unit until fully assembled (Fig. 6). Caution: leaks can occur if the
accessory is not locked correctly.
3. Rotate the assembled accessory (K or L) and position it on the motor unit
(Fig. 7).
4. Then turn the assembled accessory (K or L) through a quarter turn
clockwise (Fig. 7).
5. Plug in the appliance and turn the Control knob (E) to the desired position
or apply a few pulses. To stop the appliance, turn the control knob (E) to
position zero.
6. Unlock the accessory by turning it through a quarter turn in the
anticlockwise direction. Remove the assembled accessory (K+M or L+M)
from the motor unit. Turn it over before opening to avoid any spillage of
your preparation. Then you can unlock the blade unit (K1 or L1). The
blades are very sharp: handle them with caution to avoid injury. You
can then remove the preparation in the bowl.
Warning : you can use the accessories with solid ingredients only. You
can pour liquid ingredients in the blender jug (F) only.
50
. The overall cooling time may vary
Advertisement
