Using Your Blender - OBH Nordica PerfectMix LH811DS0 Manual

ASSEMBLING AND FITTING THE JUG
Moisten the seal (F3) (even if already fitted on the blade unit (F1). Be careful
to correctly fit the seal (F3) back onto the blade unit (F1) the correct way up
(Fig 11).
• Check the seal is in place on the blade unit.
• Turn the jug upside down and place the blade unit on the base of the jug
(Fig 1).
• Fit the locking ring (Fig. 2) and lock it by rotating it through a quarter turn in
the clockwise direction.
• Make sure the locking ring is locked correctly: the two arrows must be
aligned (Fig 3).
• Add the ingredients to the assembled jug without exceeding the maximum
level indicated:
• 1.5 L for thick mixtures
• 1.25 L for liquid preparations
Warning : Do not pour boiling liquids (over 80°C/176°F) into the jug.
Fit the lid (F5) on the jug (Fig. 8). To avoid any splashes during blending
•
make sure that the curved tabs on the lid are aligned with the spout and
handle (Fig. 9). Fit the measuring cap (F6) in the hole on the lid (Fig. 8)

USING YOUR BLENDER

• Once the blender jug is locked correctly on the motor unit, plug in the
appliance. The lights on the appliance flash twice and you hear a beep.
Turn it on using the desired function.
Speed selection: Turn the control knob (E) to choose the desired speed;
•
the speed increases gradually between min and max. The intensity of the
lights on the appliance increase gradually as the speed increases. You can
change the speed as required during preparation.
"Pulse" function: Turn the control knob (E) to the "Pulse" position. Using
•
a succession of pulses gives finer control for precise preparations. In this
position, the appliance starts directly on maximum speed. It stops as soon
as you release the knob. The light remains on when the pulse function is in
use.
• Function
This function is used to prepare smoothies, milkshakes and fruit cocktails.
The speed is pre-programmed for best results. To use this function, press
the "Smoothie" button (B). The light remains on during this cycle and
switches off when the cycle is finished. The program stops automatically
and beeps 4 times. You can stop it before the end by pressing the
"Smoothie" button (B) again.
• Function " Ice crush"
You can use this function to crush ice finely with pre-programmed
operating cycles and speed. To use this function, press the "Ice crush"
button (C). The light remains on during this cycle and switches off when
the cycle is finished. You hear 4 beeps. The program stops automatically
but you can stop it before the end by pressing the "Ice crush" button (C)
again.
" Smoothie"
49