Table of Contents
Advertisement
Pressing the power button shows
the start screen (Fig. 1) during a
short time. In the bottom left
screen it is shown the UVision
firmware.
Then the unit will try to link
showing the connecting screen (Fig.
2). This screen will disappear after
a brief moment
If
the
unit
has
configured, but if it has not been
paired then the message will stay
on screen waiting for configuration.
NOTE: make sure that the UMeter+, UValve or UCount unit is powered on before
pairing the UVision.
Follow the below instructions to pair the UVision:
Starting from the connecting screen (figure 2) press and hold the power button until
"setup" is shown on the
screen (figure 3). Release the
button.
Next the configuration screen is
shown automatically (figure 4). The
unit remains waiting for the hose
reel number that you want to
associate.
The hose reel number starts to
increase automatically. When the
desired hose reel number is shown,
press and release the power button
to set it. In case that the desired
hose reel number is missed, press
and hold the power button until the
counter restarts.
Once that the hose reel number is
set, the screen shows that the
configuration is performed and the
unit
restarts
(figure
restarting the screen shows that
the UVision is configured and ready
to operate (figure 6).
NexU INSTALLATION MANUAL
already
been
5).
After
Rev 3 (XXXX 2019)
52
Advertisement
Table of Contents
