Table of Contents
Advertisement
be connected for
be connected for communications then only SCREEN/WHITE/BLUE have
connected (no matter if it is made in BUS IN or BUS OUT connector)
(no matter if it is made in BUS IN or BUS OUT connector)
(no matter if it is made in BUS IN or BUS OUT connector)
4. RS232 Port: Allows peripheral devices connections
Allows peripheral devices connections. Mainly for service.
5. USB Port: Allows peripheral devices connections
Allows peripheral devices connections. Mainly for service
6. iButton Reader: Allows identification
7. Power Connector: IEC Power Socket for 240 VAC or 110 VAC
Power Connector: IEC Power Socket for 240 VAC or 110 VAC, 50 / 60 Hz
this connector must be 3 x 1.5 mm2 minimum.
8. RFID reader: Allows identification via RFID card.
RFID reader: Allows identification via RFID card.
Wiring for UDat and UDat+ is as
Wiring for UDat and UDat+ is as follow.
Be aware that this is the standard way of connecting. Please check chapter 3.3 for
Be aware that this is the standard way of connecting. Please check chapter 3.3 for
Be aware that this is the standard way of connecting. Please check chapter 3.3 for particular
wiring.
NexU INSTALLATION MANUAL
INSTALLATION MANUAL
communications then only SCREEN/WHITE/BLUE have to be
Allows identification via iButton® key
must be 3 x 1.5 mm2 minimum.
Mainly for service.
. Mainly for service and updating.
, 50 / 60 Hz. Wiring for
Rev 3 (XXXX 2019)
15
Advertisement
Table of Contents
