Table of Contents
Advertisement
Rev 3 (XXXX 2019)
The wiring has to be made as shown in the picture.
If two CANBUS connections have to be made, then connect the upper terminal in the same
way. In this case, the EOL resistor has to be deactivated (see local parameters chapter)
Regarding LED indications and buttons, UNet label indicates the meaning of each one.
1.- Reset button.
In the event of restarting the UNet, it has
to be pressed.
2.- Status Indicator
Power: It indicates if there is power to
the unit
Status: It indicates if CANBUS is OK
Onine: It indicates if it is ready for
working.
RX: Communication Flow to the unit
TX: Communication Flow from the unit
28
NexU INSTALLATION MANUAL
Advertisement
Table of Contents
