Advertisement
Door
Door lever
Feed pawl
Pin
Door
MODEL IDENTIFICATION
SEQUENTIAL TRIP
The Sequential Trip requires the operator to hold the tool against the work before pulling the trigger. This
makes accurate fastener placement easier, for instance on framing, toe nailing and crating applications.
The Sequential Trip allows exact fastener location without the possibility of driving a second fastener
on recoil, as described under "Contact Trip".
The Sequential Trip Tool has a positive safety advantage because it will not accidentally drive a
fastener if the tool is contacted against the work-or anything else-while the operator is holding the
trigger pulled.
e Push the door lever to open the door.
r Push in the pin coil along the bridge until it has reached the end. Put the first pin into
the hose.
CAUTION:
Confirm that the first pin has been entirely set in front of the feed pawl (into the
nose).
t Push the door to close it.
CAUTION:
Push the door firmly until the door lever has clicked.
y Close the magazine cap.
u Connect the air chuck to the air plug. You are now ready to drive the pins.
SEQUENTIAL TRIP
Identified by ORANGE TRIGGER.
10
Advertisement
