Max HN25C Operating And Maintenance Manual page 11

High pressure concrete tool

SINGLE FIRE OPERATION (SEQUENTIAL TRIP)

For single fire operation, depress the contact arm against the work surface and pull the trigger. Tool can

not fire a second nail until the trigger is released and tool can cycle.

Trigger lock dial

PROCEDURE

q Depress the contact arm.

w Pull the trigger.

TRIGGER LOCK MECHANISM

The tool is equipped with a trigger lock mechanism. Push and rotate the trigger LOCK

to the trigger UNLOCK position before driving nails.

Trigger

REPLACING THE CONTACT TIP

The machine comes with the contact tip as accessories. See the following for the

replacement method.

WARNING:

When replacing the attachment, be sure to lock a trigger and remove an air hose.

HOW TO REMOVE PLASTIC SHEET

As pins are driven the plastic sheet will feed out of the tool. When sufficient strip has

been fed out it can be torn away by pulling against the tear edge in the nose.

Table of Contents