Fill Valve Will Not Turn On - Jandy Pro Series Installation And Operation Manual

Page 18
ENGLISH
5.4

Fill Valve Will Not Turn ON

Is the sensor light on?
NO
After 20 seconds,
PCB is bad.
is the fill light on?
Red
What color
is the light?
Is there a break in wiring
YES
between controller and
sensor or valve?
NO
Time-out sequence
has taken effect.
Call 1.800.822-7933.
Did the fill light turn
on after 20 seconds?
NO
Verify right voltage supply.
Check initial observations.
Check for power at
PCB is bad.
the valve connection
for 24VAC.
Jandy Pro Series Levolor
Models K-2100
Fill Valve Will Not Turn ON
YES
Is the power light on?
NO
YES
Is the water touching
YES
Green
Fix wiring.
YES
NO
Is power at the blue wires at
the control box 24VAC?
Fill sensor
is shorted.
II Electronic Water Leveler
®
NO
the fill sensor?
YES
NO
Sensor light will not illuminate until water drops
below low water sensor.
Fill mode will not activate without
low water sensor light on.
Disconnect the yellow and yellow/blue
sensor wires from the controller.
YES
Did the sensor
light turn on?
NO
YES
Is power at the valve
connection 24VAC?
YES
YES
Did valve turn on?
|
Installation and Operation Manual
Verify correct voltage supply.
Turn on power.
Bad transformer
Check initial observations
and verify if correct.
PCB is bad.
NO
Wire between valve and
control box is broken.
Check and fix connections.
NO
Possible Causes:
1. Valve needs cleaning.
2. Diaphragm valve gate
control is closed clockwise.
3. Diaphragm is bad.
4. Solenoid port needs
cleaning.
5. Solenoid is bad.