Installing The Carrier Frame - Toro 30555 Operator's Manual

2. Chock the rear wheels to prevent the machine from
moving during the installation.
3. Loosen the wheel nuts that secure the front wheels to
the machine.
4. Use jacks to raise the front wheels off the floor.
5. Support the machine with jack stands or blocking.
6. Remove the lug nuts and the front wheels from the
machine.
2

Installing the Carrier Frame

Parts needed for this procedure:
1 Carrier frame
1 Right lift arm
1 Left lift arm
2 Bolt (1/2 x 1-1/2 inches)
4 Spacer
2 Pivot pin
2 Cotter pin (5/32 x 1-3/4 inches)
2 Caster fork
2 Caster wheel
2
Spanner
2 Bolt (1/2 x 5 inches)
4 Flat washer
2 Locknut (1/2 inch)
8 Thrust washer
2 Lynch pin
2 Rear cradle
2 Cradle spacer
6 Bolt (3/8 x 2 inches)
6 Flange nut (3/8 inch)
2
Cushion
2 Cushion spacer
4 Screw (#10 x 1 inch)
4 Locknut (#10)
Installing the Spacer
1. Install the spacers into the pivot bracket
1. Spacer
2. Verify the cutout for the roll pin on the spacer is
aligned with the inset for the roll pin on the pivot
bracket (Figure 4).
1. Pivot-arm inset
3. Repeat the previous steps to the other side of the
machine.
7
(Figure
Figure 3
2. Pivot bracket
Figure 4
2. Spacer
3).