Setup; Preparing The Machine - Toro 30555 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
DANGER
If you start the engine and allow the PTO shaft to
rotate, serious injury could result.
Do not start the engine and engage the PTO lever
when the PTO shaft is not connected to the gearbox
on the mower deck.
Note: Determine the left and right sides of the machine
from the normal operating position.
Important: The weight transfer kit must be installed to
a Groundsmaster 200 Series traction unit when installing
the 52 inch deck.
Description
No parts required
Carrier frame
Right lift arm
Left lift arm
Bolt (1/2 x 1-1/2 inches)
Spacer
Pivot pin
Cotter pin (5/32 x 1-3/4 inches)
Caster fork
Caster wheel
Spanner
Bolt (1/2 x 5 inches)
Flat washer
Locknut (1/2 inch)
Thrust washer
Lynch pin
Rear cradle
Cradle spacer
Bolt (3/8 x 2 inches)
Flange nut (3/8 inch)
Cushion
Cushion spacer
Screw (#10 x 1 inch)
Locknut (#10)
Mower deck
Clevis pin
Hairpin
No parts required
Qty.
–
Prepare the machine before installation.
1
1
1
2
4
2
2
2
2
2
2
4 Install the carrier frame.
2
8
2
2
2
6
6
2
2
4
4
1
4 Install the mower deck.
4
–
Install rear weight.
1

Preparing the Machine

No Parts Required
Procedure
1. Move the machine onto a level surface, engage the
parking brake, put the traction pedal into the N
position, the PTO lever into the O
the engine, and remove the key from the ignition.
6
Use
EUTRAL
position, shut off
FF