Installing The Bagger Frame - Toro 79336 Operator's Manual

7. Install a flat weight to the holding bracket and move it
rearward, flush with the bracket (Figure 9).
1
1. Flat weight
2. Suitcase weight
8. Install a suitcase weight in front of the flat weight
(Figure 9). The groove in the suitcase weight should
be facing rearward.
9. Secure the weights to the bracket with a keyed cross
bar (Figure 9). Install the bar and rotate it 90 degrees
downward to lock it in place.
10. Once all weights and brackets have been installed, go
back and check that all fasteners are tight. Tighten as
necessary.
Important: Whenever you remove the bagger
attachment, remember to remove the front weights to
return the proper stability to the machine.
2
3
G014880
Figure 9
3. Keyed cross bar
2

Installing the Bagger Frame

Parts needed for this procedure:
1 Bagger frame support bracket
1 Support spacer plate
2 Self tapping screw (5/16 x 3/4 inch)
2
Bolt (5/16 x 1 inch)
4 Lock nut (5/16 inch)
1 Angled bracket
2 Carriage bolt (5/16 x 3/4 inch)
1 Bagger frame
1 Clevis pin (1/2 x 2-1/4 inch)
5 Hair pin cotter
2 Rod
4 Washer
Procedure
1. Locate the bagger frame support spacer plate and
bracket in loose parts. Install the plate and bracket to
the machine frame as shown in Figure 10. Secure the
plate and bracket to the frame using two bolts (5/16 x
1 inch) and two lock nuts (5/16 inch).
G014881
6
1. Machine frame
2. Support spacer plate
3. Support bracket
2. Secure the support bracket to the bottom of the
machine frame from below using two self tapping
screws (5/16 x 3/4 inch) as shown in Figure 11.
8
1
3
2
5
Figure 10
4. Bolt (5/16 x 1 inch)
5. Draw bar hole
6. Lock nut (5/16 inch)
4