Installing Rear Weight; Product Overview; Specifications; Attachments/Accessories - Toro 30555 Operator's Manual

Figure 22
1. Bolt (3/8 x 1/2 inch)
2. Lock washer
6. Torque the bolt to 37 to 45 N∙m (27 to 33 ft-lb).
4

Installing Rear Weight

No Parts Required
Procedure
The 2 wheel drive Groundsmaster 200 Series, 3280-D, and
3320 traction units comply with the ANSI B71.4-2012
standard when equipped with rear weight. Refer to the
chart in the traction unit Operator's Manual to determine the
combinations of weight required. Order the parts from your
Toro Distributor.
The 4 wheel drive Groundsmaster 200 Series and 3280-D
traction units do not need additional rear weight to comply
with the ANSI B71.4-2012 standard.
3. PTO guard

Product Overview

Specifications

Note: Specifications and design are subject to change
without notice.
Width of Cut 1314 mm (51-3/4 inches )
Height of Adjustable from 25 to 102 mm (1 to 4 inches) in
Cut 13 mm (1/2 inch) increments
Net Weight 153 kg (338 lb)

Attachments/Accessories

A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand its
capabilities. Contact your Toro Distributor.
To best protect your investment and maintain optimal
performance of your Toro equipment, count on Toro genuine
parts. When it comes to reliability, Toro delivers replacement
parts designed to the exact engineering specification of our
equipment. For peace of mind, insist on Toro genuine parts.
13