Operation; Adjusting The Height Of Cut; Adjusting The Rollers - Toro 30555 Operator's Manual

Operation

Determine the left and right sides of the machine from the
normal operating position.

Adjusting the Height of Cut

1. Use the following figure to determine the holes to
be used to set the height of cut for the mower deck
(Figure 23).
Figure 23
1. 25 mm (1 inch)
2. 38 mm (1-1/2 inches)
3. 51 mm (2 inches)
4. 64 mm (2-1/2 inches)
2. Use a clevis and hairpin to secure each section of the
mower deck to the carrier frame
Figure 24
1. Hairpin
Note: Have an assistant to help you raise the mower
deck when you install the clevis and hairpins.
3. Use the cushion spacer if the clevis pin does not
contact the cushion at the height of cut
5. 76 mm (3 inches)
6. 89 mm (3-1/2 inches)
7. 102 mm (4 inches)
(Figure 24).
2. Clevis pin
(Figure 25).
1. Screw (#10 x 1 inch)
2. Cushion

Adjusting the Rollers

Adjust the rear rollers on the mower deck if the height of cut
is set to 25 mm (1 inch) or 38 mm (1-1/2 inches).
1. Move the machine onto a level surface, engage the
parking brake, shut off the engine, and remove the key
from the ignition.
2. Raise the cutter deck to access the rear rollers.
3. Support the carrier frame to prevent it from lowering
during the procedure.
4. Remove the cotter pin that secures the roller shaft to
the center bracket.
1. Outer bracket
2. Roller
3. Cotter pin
5. Pull the shaft out of the center bracket and then slide it
out of the outer bracket.
6. Move the assembly to the appropriate location.
14
Figure 25
3. Cushion spacer
4. Locknut
Figure 26
4. Roller shaft
5. Center bracket