Toro 30555 Operator's Manual page 8

Installing the Pivot Pin
1. Insert the pivot pin hole of the lift arm between the
2 spacers (Figure 5).
Note: Mount the lift arm with the bend positioned
outward.
1. Pivot pin
2. Insert the pivot pin through the spacers and lift arm
(Figure 5).
Note: Ensure that the roll pin on the pivot pin is
inserted into the inset of the pivot arm.
3. Insert the cotter pin into the hole in the pivot pin
(Figure 6).
1. Pivot pin
4. Spread apart the open end of the cotter pin to secure
the pivot pin.
5. Repeat the previous steps to the other side of the
machine.
Figure 5
2. Lift arm
Figure 6
2. Cotter pin
Connecting the Lift Cylinder
1. Remove the outer-cotter pin securing the cylinder pin
to the lift cylinder
1. Cotter pin
2. Cylinder pin
2. Insert the cylinder pin through the lift arm and lift
cylinder (Figure
3. Insert the cotter pin into the cylinder pin
Note: Spread apart the open end of both cotter pins
to secure the cylinder pin.
4. Repeat the previous steps to the other side of the
machine.
Configuring the Brake Spring
1. Remove the cotter pin from the clevis pin holding the
brake strut and yoke together
1. Brake return spring
2. Install the short end of the spring into the hole in the
clevis pin to retain the parts together.
8
(Figure 7).
Figure 7
3. Lift cylinder
4. Cotton pin
7).
(Figure
(Figure 8).
Figure 8
2. Slotted hole
7).
1
2
G010542