Toro 30555 Operator's Manual page 11

3
Installing the Mower Deck
Parts needed for this procedure:
1 Mower deck
4 Clevis pin
4 Hairpin
Installing the Mower Deck
1. Raise the carrier frame
Note: You must run the engine to lower the carrier
frame on the GM 3280-D and the 3320 models.
2. Move the mower deck under the carrier frame
15).
Figure 15
1. Mower deck
3. Lower the carrier frame over the mower deck.
Note: You must run the engine to lower the carrier
frame on the GM 3280-D and the 3320 models.
4. Use the 4 clevis pins and hairpins to secure the mower
deck to the carrier frame at the desired height
16).
(Figure 15).
(Figure
2. Carrier frame
(Figure
1. Hairpin
Note: Have an assistant use a block and lever to raise
the mower deck as you install the clevis and hairpins.
5. Use the following figure to adjust the height of cut of
the mower deck
1. 25 mm (1 inch)
2. 38 mm (1-1/2 inches)
3. 51 mm (2 inches)
4. 64 mm (2-1/2 inches)
6. Use the cushion spacer if the clevis pin does not rest
on the cushion (Figure
11
Figure 16
2. Clevis pin
(Figure 17).
Figure 17
5. 76 mm (3 inches)
6. 89 mm (3-1/2 inches)
7. 102 mm (4 inches)
18).