Toro 30555 Operator's Manual page 12

1. Screw (#10 x 1 inch)
2. Cushion
Connecting the Power Take-off
1. Remove the hardware that secures the PTO assembly
to the traction unit and set it aside for later use
19).
1. Traction unit
2. Locknut
3. Flat washer
2. Remove the hardware used to secure the PTO guard
to the gearbox (Figure
Figure 18
3. Cushion spacer
4. Locknut
Figure 19
4. End yolk
5. Bolt (5/16 x 3 inches)
20).
1. Bolt (3/8 x 1/2 inch)
2. Lock washer
3. Apply anti-seize grease to the inside of the end yolk
and to the gearbox-spline shaft.
(Figure
1. Spline shaft
2. Locknut
3. Roll pin
4. Use the 2 bolts (5/16 x 1-3/4 inches), flat washers,
locknuts, and roll pin to secure the end yolk to the
gearbox-spline shaft
Note: The 2 bolts (5/16 x 1-3/4 inches), flat washers,
locknuts, and roll pin are contained in the loose parts
kit that shipped with the traction unit.
5. Slide the PTO guard over the end yolk and secure it
with the 2 bolt (3/8 x 1/2 inch) and washer
12
Figure 20
3. PTO guard
Figure 21
4. Bolt (5/16 x 1-3/4 inches)
5. PTO guard
(Figure 21).
(Figure 22).