Advertisement
Rear Discharge Completion Kit
Base 72in Mower for Groundsmaster
Model No. 30549
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
1
2
1
Preparing the Machine
No Parts Required
Preparing the Machine
1.
Park the machine on a level surface.
2.
Shift to the N
EUTRAL
3.
Lower all attachments (if equipped).
4.
Engage the parking brake.
5.
Shut off the engine and remove the key.
6.
Disconnect the battery; refer to your machine
Operator's Manual.
© 2020—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Description
No parts required
Carriage bolt (5/16 x 3/4 inch)
Flange nut (5/16 inch)
Left baffle
Center baffle
Right baffle
Rear shield
Blade
Anti-scalp cup
Blade bolt
position.
Register at www.Toro.com.
Form No. 3438-876 Rev A
®
360 Multi-Purpose Machine
Installation Instructions
Qty.
–
Prepare the machine.
26
26
1
1
1
Install the baffles.
1
3
3
3
Original Instructions (EN)
All Rights Reserved *3438-876* A
Printed in the USA
Use
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Toro 30549
Summary of Contents for Toro 30549
- Page 1 Form No. 3438-876 Rev A Rear Discharge Completion Kit Base 72in Mower for Groundsmaster ® 360 Multi-Purpose Machine Model No. 30549 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty.
- Page 2 Installing the Baffles Parts needed for this procedure: Carriage bolt (5/16 x 3/4 inch) Flange nut (5/16 inch) Left baffle Center baffle Right baffle Rear shield Blade Anti-scalp cup Blade bolt Procedure DANGER Mechanical or hydraulic jacks may fail to support the machine and cause a serious injury.
- Page 3 g318353 Figure 1 1. Flange nut (5/16 inch) 4. Decal 7. Right baffle 2. Rear shield 5. Left baffle 3. Carriage bolt (5/16 x 3/4 inch) 6. Center baffle...
- Page 4 Install the blades, anti-scalp cups, and blade bolts (Figure 2). Tighten the blade bolts to 115 to 149 N·m (85 to 110 ft-lb). Important: Ensure the curved part of the blade is pointing toward the inside of the mower deck. g004741 Figure 2 1.
Need help?
Do you have a question about the 30549 and is the answer not in the manual?
Questions and answers