Icom IP503H Instruction Manual page 63

5
OPTIONAL PRODUCTS
■ Installing the MBA-7/MBF-1 (continued)
3. Make sure that the surface where MBF-1 is attached to is clean and dry, then attach the MBF-1.
4. Adjust the angle and position of MBA-7 with the MBF-1's adjusting dial and screw.
Adjust the angle between
+/–20 degrees
*Apply the adhesive sponge, to firmly fix the mount.
5. Attach the BC-218 to the MBA-7, then connect the DC cable.
6. Attach the strap for the fall prevention.
e Adjust the position by the dial or screw.
Adjust the height
and then fix the
position using a hex
wrench.
Adhesive sponge*
BC-218
w
Push down the base lever to attach
Base lever
Dial
Suction pad
q
Approximately 90 mm Approximately 90 mm 2 2
Screws (supplied with MBA-7)
CP-22 or CP-23L
5-26
Suction pad cover
Suction pad
Remove the suction pad cover,
then firmly attach the suction pad to the dashboard.